Sig Sauer - Manufacturers - Top Gun Supply

Factory Sig Sauer P290 9mm magazines. Stainless steel construction with a 6 round capacity. Bull nose skirted follower with dimple, with extended and flush baseplate.

Sig Sauer P290 holster with durable belt clip for belts up to 1.5". Outside the waist band carry, right handed, made by SIGTAC with the Sig Sauer logo. Fits P290 with or without laser attached.

Sig Sauer Trigger Guard Laser for the P238 pistol. Red laser assembly mounts onto the trigger guard and is activated by side buttons.

The Sig Sauer Romeo5 Compact Red Dot Sight is a military-grade optic designed work under any circumstances. Features MOTAC (Motion Activated Illumination System), a motion sensor for automatic on/off, 2 MOA red dot with 10 illumination settings, aircraft grade aluminum housing, CR2032 battery, low profile mount and co-witness riser mount, as well as waterproof and fogproof performance. The Romeo5 is optimized for today's MSR/AR platforms.

Sig Sauer factory Hammer Reset Spring for all SIGPRO models, SP2022, SP2009, SP2340.

SIG factory Magazine Base Plate for P220 Compact 6RD magazines.

Sig Sauer factory Magazine Follower for (Italian) P226 9mm 15RD magazines.

Kit Contains:

• Recoil Springs (Red for Compact/Carry & Green for Full Models)
• Trigger Bar Spring
• Slide Catch Lever Spring
• Decocking Lever Spring
• Outer Roll Pin
• Inner Roll Pin
• (4) Grip Screws
• (4) Grip Screw Washers

Sig Sauer factory replacement recoil spring for P226 9mm and P250 Full Size 9mm.

Sig Sauer factory Hammer Stop for P226/227 models.

A Multipurpose tool for Sig Sauer handguns featuring a correctly shaped screwdriver tip for removing grip screws, installation and removal of magazine catch and sear spring and a tip to aid in mainspring removal and installation. 5/16" drive. The screwdriver may not fit the older style P226 screws with the smaller .115" shank.

SIG factory Firing Pin for P220, P227 stainless steel slide models .

SIG factory Firing Pin Positioning Pin for early P229 .40S&W and P229 .357SIG models thru serial number "AE".

SIG factory Magazine Base Plate for (old style) P220 blued magazines that use the magazine spring to lock the plate.

SIG factory steel base plates for the Sig P226 .40/357 12RD and 9mm 15RD magazines. These are the newer Mec-Gar base plates and will fit the older production magazines along with the Mec-Gar brand magazines. Will not fit US made magazines.

Sig Sauer P226 10 round magazine base. This a factory replacement base for P226 9mm 10RD magazines and P226 .40S&W 10RD magazines. Will only fit 10RD magazine tubes.

SIG factory steel base plates for the Sig P226 9mm magazines. These are the original German base plates which are slightly shorter than the current production and will fit any of the factory P226 9mm, .40 or .357 magazines except the 10RD. Will work with the P228/P229 X-Grip with no modification required.